Electrical Connection - Teka CP 15 GS Guía De Uso

the latter without any need to have a
separating shelf.
To build-in the appliance which is combined
with the crockery
instructions set
instructions and fitting booklet.
The relevant installation dimensions are
indicated in mm in the diagrams shown at
the end of this booklet. Proceed as follows:
1. Place the crockery warmer on the shelf
and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the
unit.
2.
is properly levelled and is sitting evenly
on the shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the
two screws provided.
24
warmer, follow
out in the respective

Electrical Connection

The crockery warmer is equipped with a
power cable and plug for single phase
the
current. We
connected to a socket that is easily
accessible after installation.
If the crockery warmer is to be installed
on a permanent basis it should be installed
by a qualified technician. In such a case, the
appliance should be connected to a circuit
with an all-pole circuit breaker with a
minimum separation of 3 mm between
contacts.
The data
connection are described on the crockery
must be compatible with those of the power
outlet you are going to use.
WARNING: THE CROCKERY WARMER
MUST BE CONNECTED TO EARTH.
The manufacturer and retailers do not
accept responsibility for any damage that
may be caused to people, animals or
property if these installation instructions are
not observed.
advise that the
necessary for the
plug is
electrical
and these