Tabla de contenido
Publicidad
TECHNICAL INFORMATION
When no external input-output device is available
this connector must be closed with the supplied
mating connector that short-circuits the START
and INTERLOCK inputs with the GROUND input
(see the following figure).
How to connect the output open collector of
the controller
Here below there are the typical connections of the
output open collector of TV551/701 Navigator to an
external system. Two cases are considered:
1. the customer supplies the 24 Vdc
2. the customer does not supply the 24 Vdc.
Case 2 with relay utilisation
Please note that on the connector a 24 Vdc, 60 mA
voltage, a GROUND signal and the open collector
pin are available.
Case 1
Case 2 with transistor utilisation
33
87-900-934-01(B)
Publicidad
Tabla de contenido
