General Safety Instructions; Technical Data; Layout And Items Supplied; Intended Use - Gardol GLH 250 SB Manual De Instrucciones Original

Anleitung GLH_250_SB_SPK7:_
Packaging
The unit is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this
packaging can be reused or recycled.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
Read the operating instructions carefully and
comply with them at all times. It is important to
consult these instructions in order to acquaint
yourself with the unit, its proper use and the
important safety regulations.
Keep this manual in a safe place, so that the
information is available at all times.
If you give the equipment to any other person,
make sure that you pass on these operating
instructions as well.
We can accept no liability for damage or
accidents which arise due to non-compliance
with these instructions.
1. Safety information
The corresponding safety information can be found
in the enclosed booklet.

2. Technical data

Voltage:
Power rating:
Cutting unit idling speed
Branch diameter:
L sound pressure level:
pA
L sound power level:
WA
Weight:
Operating mode S6 40%: Continuous operation with
idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 40% of the cycle at the specified
rating and must then be allowed to idle for 60% of
the cycle.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
27.07.2009 7:11 Uhr Seite 13
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
3. Layout and items supplied (Fig. 1-3)
1. Motor unit
2. Shredded material debris box
3. Base frame
4. Wheels
5. Wheel caps
6. Knob for setting the counter blade
7. Integral power plug
8. Transport handle
9. Reverse running switch
10. ON/OFF switch
11. Legs (including fastening screw)
12. 3x screws for fitting the motor unit
13. 3x washers for fitting the motor unit
14. 2x sets of screws for fitting the wheels (including
wheel sleeves, washers and nuts)
15. 2x open-ended spanners (10/13 mm)
16. 1x Philips screwdriver
Not illustrated: 1 x safety instruction booklet
4. Proper use
230 V ~ 50 Hz
This electric garden refuse shredder is designed only
2500 W (S6-40%)
for shredding organic garden waste. Place biologi-
2000 W (S1)
cally degradable material, e.g. leaves, branches,
40 min -1 dead flowers etc., into the loading funnel inlet.
Please note that our equipment has not been
max. 40 mm
designed for use in commercial, trade or industrial
87,3 dB (A)
applications. Our warranty will be voided if the
96,3 dB (A)
machine is used in commercial, trade or industrial
28 kg
businesses or for equivalent purposes.

5. Installation

1. Screw the motor unit (Fig. 4/Item 1) and the base
frame (Fig. 4/Item 3) together. Use the screws
(Fig. 3/Item 12) and washers (Fig. 3/Item 13) to
do so.
2. Fit the wheels to the base frame. To do so, slide
one sleeve each into the hole in each of the
wheels (Fig. 6). Then insert one screw with
washer through each sleeve (Fig. 7) and screw
the wheels to the base frame (Fig. 8). To do so,
GB
13