Troubleshooting - Gardol GLH 250 SB Manual De Instrucciones Original

Anleitung GLH_250_SB_SPK7:_
GB

10. Troubleshooting

Fault
The motor does not start
Material is not drawn in by the
shredder
The material is not shredded
properly
16
27.07.2009 7:11 Uhr Seite 16
Cause
Power failure
The shredding blade is running in
reverse.
Material blockage in the filling
funnel
The shredding blade is jammed
The counter blade is not set
correctly.
Remedy
Check the mains lead, plug and
fuse.
Change the direction of rotation.
Change the direction of rotation
and pull the material out of the
funnel. Feed in thick branches
again so that the blade does not
immediately engage again in the
notches it previously cut.
Change the direction of rotation.
The blade will now release the
jammed material.
Adjust the counter blade. See
section 6.8 on how to do so.