Price Pfister BIXBY 538 Serie Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7
7F
7E
7H
7G
7C
7D
7B
7 SECURING THREE HOLE FAUCET BODY
From underneath sink, place Washer (7A) and Locknut (7B) over Pull-Out Hose (7C)
and Supply Tubes (7D). Thread loosely onto faucet shank (7E). Make sure that Handle
(7F) is properly aligned to sink. Hand tighten Wing Nuts (7G) to Deckplate Shanks
(7H). Caution: do not over-tighten wing nuts. Remove any excess putty from around
the outside edge of Putty Plate (7J). Tighten faucet fi rmly to sink and use Flats (7K)
on Shank (7E) for leverage.
STOP
1 HOLE INSTALLATION
8
8D
8F
8C
8A
8B
7J
7K
7H
7G
7A
Go To Step 10
Go To Step 10
8E
8J
8G
8H
8C
ENGLISH
8 ONE HOLE WITH SINGLE POST INSTALLATION
Place Metal Washer (8A) and Rubber Washer (8B) over center hole of sink and into
the bottom of Mounting Ring (8C). Align Mounting Ring (8C) to the center of sink hole.
Retract Pullout Hose (8D) up through Faucet Body (8E), until the pullout hose fi tting
is fl ush with the bottom of Mounting Shank (8F). Insert Faucet Supply Tubes (8J) and
Mounting Shank (8F) through the hole in Mounting Ring (8C).
Note:Tabs (8G) on Mounting Shank (8F) must be aligned with Grooves (8H) inside
Mounting Ring (8C).
Note: Do not feed the pullout Hose (8D) back down through the spout yet.
9
9F
9 SECURING SINGLE POST FAUCET BODY
From underneath sink, place Washer (9A) and Locknut (9B) over Pull-Out Hose (9C)
and Supply Tubes (9D). Thread loosely onto faucet shank (9E). Make sure that Handle
(9F) is properly aligned to sink. Tighten faucet fi rmly to sink and use Flats (9G) on
Shank (9E) for leverage.
10
10C
10 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (10A) into the Weight (10B). Screw Quick Connector
(10C) to the free end of Pull-Out Hose (10A).
3
9E
9G
9C
9D
9A
9B
10B
10A

Publicidad

Tabla de contenido
loading

Productos relacionados para Price Pfister BIXBY 538 Serie

Tabla de contenido