Service & Maintenance - Ferm TCM1011 Traducción Del Manual Original

EN
replaced.
• Type of disk: a diamond blade with a diameter
of 180mm.
• Do not use diamond blades that do not meet
the specifications in these instructions.
• Ensure that the diamond blade is secured
properly and rotates in the correct direction.
• To replace a worn disk, please take the
following steps (Fig. 2).
Disconnect the plug from the socket.
• Remove the water tray (4, Fig. 1) from the
machine.
• Loosen the splash guard's fixing bolts and
remove the splash guard.
• Loosen the blade fixing nut (4, Fig. 2).
• Remove the counter flange (3, Fig. 2) and
blade (2, Fig. 2) and push the new blade on
the flange (1, Fig. 2). Consider the rotation
direction indicated on the blade. Attach the
counter flange (3, Fig. 2).
• Tighten the fixing nut (4, Fig. 2) and the splash
guard.
• Ensure you do not leave any tools lying on the
splash guard.
5. Service & maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine.
Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
Please clean the tool immediately after use.
6
Disconnect the plug from the socket.
• Remove the water tray from the machine and
drain the dirty water.
• Unscrew the splash guard and clean it.
• Loosen the star-shaped knob, fold up the
table, and polish the entire machine.
The machine complies with all current safety
regulations. Repairs may only be carried out by an
approved company, because repair attempts by
unqualified people may cause injuries to the user
and bystanders. Regularly check the plug and the
cable and if they are damaged they should be
replaced by an approved company. Also check
any extension cables. Damaged safety guards
and switches must be replaced before the
machine is used again.
lubrication
The machine requiers no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Warranty
The guarantee conditions can be found on the
separately enclosed guarantee card.
Ferm