iolite WISPR Manual De Instrucciones página 4

Welcome
Thank you for purchasing the WISPR™. The WISPR™ is intended
solely for the legal consumption of pipe tobacco and other legal
plant materials. Use sensibly.
Important Safety Information
Warning: The WISPR™ contains flammable gas under pressure.
Read and follow these instructions carefully. Understand fully before
you first use your WISPR™. Failure to follow these safety instructions
could result in injury or damage. We recommend you keep these
instructions in a safe place for future reference. The following
general warnings are for your safety and the safety of others nearby:
• Keep out of reach of children.
• Do not expose your WISPR™ to heat above +50°C (+120°F)
and avoid prolonged exposure to the sun.
• Do not puncture or incinerate your WISPR™.
• Do not attempt to dismantle, readjust or repair. To do so will
invalidate the warranty. your WISPR™ is not user serviceable,
apart from those spare accessories such as mesh screens
and filling chambers.
• Transportation of Hazardous Materials Regulations forbids the
carriage of butane or other flammable gas products on passenger
aircraft. Do not pack your WISPR™ with butane gas in it, or any
other flammable gas item, in any checked or carry-on baggage.
• Do not drop your WISPR™.
• Do not use if WISPR™ is damaged.
• Dispose of in accordance with local regulations.
• Ensure gas flow has stopped and allow your WISPR™ to cool
before replacing it in its carrying pouch.
• The manufacturer is not responsible for any damage or personal
injury caused by inappropriate, incorrect or irresponsible use.
• WISPR™ is not a medical device.
• Fill only in a well ventilated area. Do not refill your WISPR™ near
a naked flame or combustible products. Use only high quality
butane cigarette lighter gas.
• Caution: Filling chamber gets hot. Temperatures of approx.
190°C (374°F) are reached in the filling chamber. Take great care
when removing filling chamber during or immediately after use.
6
Operate in 10 Easy Steps
1
Fill it up
Make sure the on/off switch is in the off
position (no red) before filling.
To fill, hold vertically with the gas input
valve upwards as illustrated. Push the gas
re-fill cylinder down onto the filling valve.
Stop filling when the gas spills from the
valve and do not overfill.
In the event of overfilling, you must allow
a period of 5 minutes before switching
on. We only recommend Vector Gas and
Newport Gas.
To aid ignition, for first gas fill and subsequent
fills where your WISPR™ has run completely
out of gas, we recommend switching on
the gas flow for 10-15 seconds approx
(until you can hear a strong gas flow) before
attempting to ignite.
Prepare Pipe Tobacco/
2
Plant Material
For optimum results we recommend you
grind pipe tobacco/plant material before
use. This insures that your plant material
or pipe tobacco is vaporised efficiently.
7