Before Use; Operation - cecotec BAMBA PRECISIONCARE PROCLIPPER TITANIUM Manual De Instrucciones

EN

3. BEFORE USE

• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Make sure all the components are included and in good conditions,
otherwise, contact immediately the o��� Technical Support
Service of Cecotec.
• Oil the device's blades before the �����

4. OPERATION

• Connect the device to a power supply.
• Turn on the clipper with the on/off switch.
Note: An audible click may sometimes be heard when switching
the equipment on, it is a result of the drive unit switching on. This is
completely normal.
How to adjust the blade fixing screw
The blades are � ed to the optimum position during manufacturing.
Despite this, it can be ����due to voltage ������� U se the
blade ��� screw to reposition the blades at the desired position if
necessary.
1. Switch the clipper on.
2. Turn the adjustment screw clockwise until you hear a noise.
3. Turn the adjustment screw anticlockwise until the noise stops.
That is the optimum position.
How to change or readjust the blades
1. Turn off and disconnect the appliance from the power supply.
2. Undo both screws on the cutting unit, remove the bottom and top
blade.
3. When assembling them back, both should be aligned. Ensure:
• Adjust the blade lever to the shortest cutting length.
• The distance between the front edge of the bottom blade and the
front edge of the top blade should be between 0.8 mm and 1.5 mm.
44