Auto Setup; Selecting The Input Source - JVC LT-22HD32U Manual De Instrucciones

Auto setup

The built-in tuner receives DVB-C, DVB-T and Cable-
analogue. At the first time you operate after the
purchase, "Auto Installation" menu will appear.
Preparation:
Turn on TV-unit (see P.7) and connect antenna.
1
Auto Installation menu will appear.
Press or to select desired language.
Then press ENTER
Auto Installation
- Setup 1 -
Language :
2
Press or to select your country.
Then press ENTER
Auto Installation
- Setup 2 -
Country :
3
Press or to select Home.
Then press ENTER
Auto Installation
- Setup 3 -
TV Location :
Please select where the TV
will be placed. The picture
will be optimized for that
location.
4
If you cancel Auto Power Off (see page 20),
press or to select Off. Then press ENTER
Auto Installation
- Setup 4 -
Auto Power Off :
Your TV has been set to
power off after 4 hours of
continuous viewing. If you
want to change this setting,
please choose Off. This
setting can also be changed
in the MENU.
5
Press or to select Antenna or Cable, then
press ENTER.
Auto Installation
- Setup 5 -
TV Connection :
Please select the method of
TV Connection.
.
German
English
French
Italian
Polish
.
UK
France
Italy
Poland
Spain
.
Home
Store
Off
1 Hour
2 Hours
4 Hours
Antenna
Cable
6
TV will search for Digital TV-channels at first.
Connect your DVB-T antenna (or DVB-C
antenna if you selected "Cable" at step 5) now.
Continue with ENTER to start auto tuning.
The tuning's progress will be displayed in
percent for confirmation.
Start Auto Tune (Digital)
Note:
• Please be patient - the Auto Tuning process
can take several minutes to complete.
7
When the tuning for Digital TV-channels is
completed, you will be asked if you want to proceed
to autotuning for Analogue TV-channels. If you wish to
start autotune Analogue TV-channels, connect your
Analogue cable-TV antenna and press ENTER.
Note:
• If you do not wish to carry out the autotuning for
Analogue TV-channels, press MENU to exit the
menu.
Start Auto Tune (Analogue)
8
When the display reads 100%, normal TV-screen will
appear.
Note:
• To cancel the auto tuning, press RETURN during the
process.
THE AUTOMATIC TUNING PROCESS WILL
ONLY START BY ITSELF THE FIRST TIME YOU
SWITCH THE SET ON. HOWEVER YOU CAN
RESTART THIS PROCESS VIA THE MENU
.
SYSTEM (see page 12).
• If you could not set up a correct pair of language and
country in this auto setup process, you will be able to
make your preferred language selection as illustrated in
page 12 (On-screen Language Selection).

Selecting the input source

Press INPUT SELECT to view a signal from
another device connected to your TV, such as a
VCR or DVD player. You can select each input
source depending on which input jacks you used to
connect your devices.
To select the video input source, press INPUT
SELECT or / , then press ENTER.
Note:
• Playback either source of DVB-T- or DVB-C-TV, and
DVB-T-Radio or DVBC-Radio depends on the selection
in step 2 of "Station search" on page 12.
Auto Installation
- Setup 6 -
Auto Installation
- Setup 7 -
11