Connecting To Other Equipment - JVC LT-22HD32U Manual De Instrucciones

Connection to other equipment

2. Connecting to other equipment

Please connect your satellite-receiver or DVD player via SCART. Make sure your SCART cable's cross-
section is at least 1 cm or more. SCART cables with less thickness may cause visible noise.
Please make the following settings inside your receiver's / DVD-player's setup-menu:
Video signal: RGB
TV-Format: 16:9
If you miss to make these settings properly, picture quality will be inferior and parts of the picture
might be missing. This is not a fault of this TV-set.
In case you need help to make this adjustment with your satellite-receiver / DVD-player, please consult
the related instructions or contact the supplier or maker of those apparatus for support.
Please use the satellite's remote-control handset to select Teletext or desired TV-station. Generally it is
not possible to store satellite TV-stations into a standard TV.
If the TV does not automatically switch to SCART, please select INPUT SCART manually, as seen on page 11.
Satellite antenna
3. Connection of a digital amplifier or digital A/V receivers
(with DTS or Dolby Digital Decoder)
DTS and Dolby Digital are two different systems. DTS-DVDs cannot be played with a Dolby Digital
receiver. Please use in this case a decoder that matches your DVDs.
• After connecting a Dolby Digital
decoder please select in the DVD
menu the Dolby Digital sound track
option.
• When a DTS sound track is played
the integrated loudspeakers are mute.
The DTS sound can only be played
digitally using the digital outlet. For
hearing a DTS decoder is necessary.
• Digital audio output is active
only when receiving DVB-T, not
when receiving analog cable TV
broadcasting.
4. Connecting to a DVD player or other AV device with Component Video outputs
If your DVD player (or other device) has Component Video output jacks, use a suitable set of leads (RCA/
Phono) to connect these to the Component Video inputs on this TV as shown - it can greatly enhance
the picture quality and performance. Please remember that you will also need to connect separate leads
(RCA/Phono) for the audio signals.
DVD player
Note:
• The Component Video input of this unit are for use with equipment which outputs interlaced signals (PAL: 576i/1080i or
NTSC: 480i/1080i) and progressive signals (PAL: 576p/720p or NTSC: 480p/720p).
36
Satellite
receiver
VCR TV
Component output
Pb
Pr
Audio output
Video recorder
(All illustrated SCART cables and
antenna cables are not supplied)
TV (Side view)
Audio digital cable
(not supplied)
Video cable (not supplied)
Y
Audio cable (not supplied)
TV
A/V receiver with Dolby
Digital decoder
TV (Side view)
To COMPONENT IN