Safety Devices; Setting The Timer; Maintenance - Novoferm NovoSpeed Flex Manual Del Usuario

English user manual
9 Safeguards
EN
The door is according to regulation equipped
with a drive with built-in anti-roll-off device and
safety light curtain.
9.1 Safety light curtain
The safety light curtain has a height of 2500
mm. When the infrared beam is interrupted by
an object in the door opening when closing the
door, the door stops moving and subsequently
opens fully. After the set time has elapsed and
if the safety light curtain is free, the door will
close again. In the closed position or when ope-
ning, the safety light curtain has no effect.
10 Adjustments
10.1

Setting the timer

The timer is set using parameter 44 as described
in the Control manual.
11

Maintenance

General
All rotation points are self-lubricating, these do
not require maintenance. Under extreme
conditions (aggressive environment) we
recommend lubricating all rotation points every
six months (or when required).
11.1
Daily
Remove all dirt and obstacles that could prevent
the operation of the door.
11.2 Weekly
Check the door for damage.
Check that the door is operating properly.
11.3 Monthly
Check the operation of the engine brake. It
should click audibly when opening and closing
the door.
11.4
Annually
The operation and structural condition of the
door must be checked once per year by a qualified
technician. A maintenance contract can be
8
This user manual must be given to the customer and must be kept within easy reach during the entire period of use.
concluded for the service work. Under extreme
conditions, in consultation with Novoferm, the
checks can be performed more often.
Important!
Annual maintenance that is not carried out
by a qualified service centre using original
parts, will void the warranty. (Please ask
your dealer).
+ IMPORTANT +++ IMPORTANT +++ IMPORTANT +
11.5 Cleaning the door panel
The door panel is made of PVC. Do not use any
corrosive substances; only use water, neutral
soap or a special door panel cleaner.
Important!
The spring and balls should be replaced
annually or every 200,000 door movements,
whichever occurs first. See 11.6
+ IMPORTANT +++ IMPORTANT +++ IMPORTANT +
11.6
Wear to parts
In order to keep the door permanently in good
condition, the following parts subject to wear
should be replaced once a year or every 200,000
door movements, whichever occurs first:
For the NovoSpeed Flex:
• The balance spring
• The plastic balls in the door panel