Tabletop Mounting; Connecting Power; Power Over Ethernet (Poe) From The Lan - 3Com 7760 Guía De Rápida Instalación

3
Connect the Ethernet cable (for power and network connection) to the port on the front of
the Access Point.
4
Snap the Access Point onto the mounting bracket.
5
To install the locking bar, push the locking bar through the opening in the side of the
mounting bracket until the hole on the locking bar is exposed. Insert a lock (not provided)
through the hole on the locking bar, and then close the lock to secure it in place.
Inserting the locking bar

Tabletop Mounting

To install the Access Point on a flat surface such as a table or desktop:
1
Remove the backing from the four rubber feet and attach them on the bottom of the
mounting bracket that is attached to the Access Point.
2
Place the Access Point on the table.
3
Connect the Ethernet cable (for power and network connection) to the port on the front of
the Access Point.

5. Connecting Power

The Access Point can be powered by the following methods:
•
By Power Over Ethernet (PoE) supplied over the LAN by a 802.3af PoE compliant device such
as a switch or hub.
•
By PoE supplied by the PoE injector included with the Access Point.

Power Over Ethernet (PoE) from the LAN

To power the Access Point using PoE provided by a switch or other 802.3af compliant device,
simply plug the network cable from the device into the Access Point's Ethernet port.
Access Point
Securing the bar with a lock
7
PoE Switch/Hub