Before Initial Operation; Temperature Setting; Operation Parameters - CORBERO CF1PKMB48GLASS Manual Del Usuario

1 Light on/off
2 Rotary knob
MIN Lowest setting (warmest cooling temperature)
MAX Highest setting (coldest cooling temperature)
SUPER Super cooling
NORMAL Recommended setting at cool ambient temperatures
Initial operation

3.2 Before initial operation

1. Clean the appliance thoroughly. Be very careful especially inside the appliance
(look at chapter
2. If the accessories inside the appliance are not fitted in their correct position,
replace them according to the image in chapter 4.
3. The appliance must be connected to the mains properly.
4. If the appliance was disconnected from the energy supply, wait 5 minutes
before you restart it.
5. Do not overfill the appliance

3.3 Temperature setting

Initial operation
:Set the thermostat to MAX until the desired cooling
temperature has been reached; then set the thermostat to NORMAL. Correcting
the temperature will be easier at a later point in time.
Super: This setting accelerates the cooling process. This setting is not
intended for permanent operatio n!
You can additionally use a fridge-thermometer
temperature.

3.4 Operation parameters

1. The appliance can only reach the relevant temperatures when:
a. the a ambient temperature meets the climatic class.
b. the doors close properly.
c. you do not open the doors too often or too long.
d. the door seals are in proper condition.
e. the appliance is properly positioned.
: Plug in the appliance and turn the rotary knob clockwise.
CLEANING AND MAINTENANCE
).
8
to check the cooling