Specification - TTI TG120 Manual De Instrucciones

Tabla de contenido

Publicidad

FREQUENCY
Frequency Range:
Vernier Range:
Vernier Accuracy:
SWEEP MODE (EXTERNAL)
Sweep Range:
Input Impedance:
Input Sensitivity:
Maximum Allowable
Input Voltage:
Maximum Slew Rate
of Sweep Voltage:
OPERATING MODES
(Specifications apply for the top decade of each frequency range and output 10V peak-to-peak into
50Ω termination).
SINE
Distortion:
Amplitude Flatness:
TRIANGLE
Linearity:
SQUAREWAVE
Rise and Fall Times:
DC
Range:
SYMMETRY
Symmetry Range:
OUTPUTS (50Ω)
Three switch-selectable ranges with 26dB vernier control within each attenuator range.
0dB Range:
–20dB Range:
–40dB Range:
DC Offset Control
Range:
TTL
Capable of driving 4 standard TTL loads.
GENERAL
Power:
Operating Range:
Storage Range:
Environmental:
Electrical Safety:
EMC:
Size:
Weight:
2
0.2Hz to 20MHz in 8 overlapping decade ranges with fine adjustment by a vernier.
>10:1 on each range.
Typically ± 5% of full scale.
Typically >20:1.
82 kΩ
Typically 0 to 2V for 10:1 sweep.
±10V
0.1V/us
Typically 2% on 200, 2k and 20k ranges.
± 0.2dB to 200kHz; ± 2dB to 20MHz.
Typically 99% on kHz ranges.
<22ns
±10V from 50Ω
Typically variable from 1:6 to 6:1 up to 500kHz.
1V to 20V peak-to peak from 50Ω (0·5V to 10V into 50Ω).
100mV to 2V peak-to-peak (50mV to 1V into 50Ω)
10mV to 0.2V peak-to-peak (5mV to 0.1V into 50Ω)
±10V from 50Ω. DC offset plus signal peak limited to ±10V (± 5V into 50Ω).
DC offset plus waveform attenuated proportionally in –20dB and –40dB position.
220V-240V AC or 110-120V AC ±10%, 50/60Hz; 30VA max. Installation Category II.
+5ºC to + 40ºC, 20% to 80% RH.
–40ºC to +70ºC
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010-1.
Complies with EN61326.
220(W) x 82(H) x 230(D) mm, (10.3 x 3.4 x 9.2") excluding feet.
1.5 Kg (3.3lb).

Specification

Publicidad

Tabla de contenido
loading

Tabla de contenido