Further Information - Axis T93F Serie Guia De Instalacion

3
Network connector (PoE IN)
4
Power connector (POWER OUT)
5
Power connector (POWER IN)
9. (AXIS T93F20, AXIS T93F10) Make sure that the housing's status LED indicates the correct
condition. See LED Indicators (AXIS T93F10, AXIS T93F20) on page 12.
10. Make sure that the camera LEDs indicate the correct conditions. See the camera's
Installation Guide.
11. Loosen the bracket adjustment screw to aim the camera to the point of interest. For
information about how to view the video stream, see the camera's Installation Guide
or www.axis.com/techsup
12. Remove the plastic wrapper from the desiccant bag and put the desiccant bag below
the lens.
1 Desiccant bag
13. Close the housing. Make sure to alternately tighten the bottom cover screws a few turns
at a time until they are tight (torque 1.5 Nm). This will help ensure that the bottom
cover gasket is compressed evenly.
NO TICE TICE
NO NO TICE
Make sure not to pinch any cables when closing the housing.
14. If using a sunshield (sold separately), place it over the top cover, adjust its position
and tighten the screws.

Further Information

Visit Axis learning center www.axis.com/academy for useful trainings, webinars, tutorials and
guides.
AXIS T93F Series
1
23