Installing The Magnetic Sensor For Horizontal Shaft Anchor Windlasses; Installing The Chain Counter; Technical Data - Lofrans GALAXY 703 Manual De Instalacion Y Uso

www.lofrans.com

2.4 Installing the magnetic sensor for horizontal shaft anchor windlasses

(see Fig. 2A – 2B – 2C)
Drill a 4 mm (~3/16") hole in the cover through which to thread the sensor cable. Fasten Part A of the support with the two screws
provided, after having positioned the O-ring in the lower part of the support. Cut Part C to measure using a hacksaw. The sensor must be
positioned at a distance of about 3 mm (~1/8") from the magnet. Fit Part C with the magnetic sensor on support A and fix it in place using
an adhesive for plastic (two-component epoxy glue) or silicone. Using the same glue, attach the sensor to Part C.

2.5 Installing the chain counter

The chain counter must be positioned so that the display will be easy to read. It should not be exposed to direct sunlight. Secure the
instrument in place with the bracket provided, tightening the two screws using a cross screwdriver.
For instructions on making electrical connections, see the attached diagram. The wires must have a minimum cross section size
of 1.5 mm². Install a 4 A (ampere) fast safety fuse on the + wire of the battery. Do not use the voltage generated by the engine battery
set to provide power.
The instrument complies with EMC standards (EN55022) and must be positioned at a distance of:
- 30 cm (~1 Ft) from the compass;
- 2 metres (~6.5 Ft) from radio transmitter equipment;
- Transmission frequency 2,4GHz

3 TECHNICAL DATA

Receiver
Power supply
No-load current intake
Protection rating
Operative temperature
Size (mm)
Weight (g)
Max output current*
*Outputs have short circuit protection and over current protection
**Excluding cable connection zone
www.busse-yachtshop.de | info@busse-yachtshop.de
F i g . 2 A
-50 cm (~1.5 Ft) from radio equipment;
-2 metres (~6.5 Ft) from the radar beam.
from 12 to 24 Vdc
max 100 mA
-
-10 : +60
126 x 78 x 23
80
2A
sensore magnetico
magnetic sensor
F i g . 2 B
Part. C
Part. A
cavo sensore
sensor cable
Transmitter
Rechargeable lithium-ion battery
Duration in continuous duty
Graphic display
Protection rating
Operative temperature
Max. chain length
Size (mm)
Weight (g)
Fig. 2C
UK
120 minutes
128 x 64 pixel
IP 66**
-10 : +60
999 metres – 999 feet
155x 65 x 45
110
5