Measurement Menu; Alarm And Functions Menu; Settings Menu - Lofrans GALAXY 703 Manual De Instalacion Y Uso

www.lofrans.com

4.3 Measurement menu

Measure
O f f
R e s e t M e a s u r e
U n i t s
E x i t

4.4 Alarm and functions menu

4.5 Settings menu

www.busse-yachtshop.de | info@busse-yachtshop.de
Use the
OFF
Turn the unit OFF
Reset Measurement
Resets the chain measurement value (0.0).
N o
F e e t
Units
Selects the unit of measurement:
Feet/ inches
Metres / centimetres
Exit
To return to the settings menu.
Use the (DOWN) or
Up Alarm
It is possible to enable the function and establish the
height at which the anchor-winch stops; after which it
is only possible to give pulsed commands.
Settable values: 1.0 - 1.5 - 2.0...5.0 (metres or feet).
Load Default
This function allows the User to revert to the original
factory default settings, thus erasing all settings
memorised.
This command must only be used in the event of
programming errors.
Exit
To return to the settings menu.
Use the (DOWN) or
Contrast
By enabling this function it is possible to start
the display contrast programming procedure.
Back Light
This function allows the user to set the backlight on
time during which the display remains lit after the last
command given (default value 60 seconds).
Light Time
By enabling this function it is possible to start the
display luminous intensity programming procedure.
Keyboard Beep
This function allows the user to enable or disable the
buzzer (emitted each time a key is pressed).
Exit
To return to the settings menu.
(DOWN) or (UP) key to move around the parameters
(UP) key to move around the parameters
(UP) key to move around the parameters
Confirm with
Select with
= Yes = No
Confirm with
Select with
= Feet = Metres
Confirm with
Confirm with
Select with
Select value with
Confirm with
Select with
= Yes = No
Confirm with
Confirm with
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
= Yes = No
Confirm with
Confirm with
UK
7