Care And Maintenance; Maintenance Instructions; Maintenance Schedule; Cleaning Inlet Sieve - Kärcher WPD 100 Advanced Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78

Maintenance instructions

WARNING
Health hazards on account of improperly maintained
device. The device may only be maintained by trained
and skilled personnel.
Use only original parts of the manufacturer or part sug-
gested by him, such as
parts and wearing parts,
accessories parts,
operating materials,
cleaning agents.
Maintenance contract
In order to ensure a reliable operation of the device, we
recommend that you conclude a maintenance contract.
Please contact your competent KÄRCHER service.
Time
daily
weekly, more frequently if necessary
every four weeks
Quarterly
annually *
*The device prompts the replacement of the filters after one year or as needed.

Cleaning inlet sieve

 Shut off water supply to the appliance.
 Briefly press the "Ambient" button in order to re-
duce the water pressure in the device.
 Remove the water inlet hose on the appliance.
 Pull out the inlet sieve using needle nose pliers.
 Clean inlet sieve.
 Insert the inlet sieve into the device.
 Connect the water supply hose to the water con-
nection on the rear of unit.
 Open the water supply.

Care and maintenance

Maintenance schedule

Performance
Clean the drip pan and the water output with disinfecting detergent (RM735, see consumables).
Check the drip pan drain (option) for obstructions.
If the device was at a standstill over night, dispense 0.5 l of each water type and pour away.
Clean the outside surfaces of the appliance with disinfecting detergent. Clean the drip pan with hot water or in the dishwasher.
Do not use detergents that contain alcohol, acidic ingredients or scouring agents for cleaning plastic surfaces.
Empty can.
Check can for cleanliness and clean or replace if required.
With portioned water dispensing, check the dispensing quantity and readjust it on the adjusting wheel compensation regulator
(see Chapter "Operation/water dispensing".
Carry out thermal hygienisation, then, depending on the device design, manually run the rinsing programme.
Check and clean the inlet sieve in the water connection (see "Care and maintenance/cleaning inlet sieve").
Clean the inlet sieve on a monthly basis in case of heavy soiling.
Have annual customer service work performed.
Replace the Active-Pure and Hy-Protect filter.
Replace Hy-Pure filter.
EN
Note:
The base and all components shown are optionally
available.
1
Base
2
Drain hose drip pan
3
Drain hose rinsing valve
4
Pressure reducer
5
Can lid
6
Can
7
CO
8
Additional cooler (WPD 600 only)
6
-
bottle
2
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wpd 200 advancedWpd 600 advanced

Tabla de contenido