Mounting - Saturn Evo Instrucciones De Montaje

ENG

MOUNTING

On page 30-35, you can find images showing the installation phases
Visit www.daken.it for the specific mounting instructions for your van.
STEP 1: WARNINGS AND POSITIONING
Before installing the device, check that the doors are perfectly aligned.
If the doors are not aligned, calibrate the doors.
Prefer smooth surfaces to areas where the van body is irregular or double.
If necessary, use the rubber protections to level and/or align the surfaces.
Before drilling, check that there is no obstacle or component inside.
The device can be installed both on the rear and on the side door of the van.
CAUTION
Do not install the device on the forepart of the side door between the
passenger door and the sliding door.
A G -
A
10
MOUNTING
.
STEP 2: DRILLING
There are several drilling options to meet all the different needs: using the
B
drill template, choose the more suitable drilling points for your van among those
available. Mark the drilling points and remove the template.
To avoid damaging the seal, drill the holes with the movable door open.
Drill according to the most suitable fixing kit for your van:
C
A. Installation with long screws, washers and nuts: holes ø4.5.
B. Installation with short screws and threaded inserts for thin sheet, max 2.5 mm:
holes ø6.
We recommend to begin with a drill bit with a smaller diameter and then
proceed with a drill bit of the chosen diameter.
Drill 1 hole ø3.5 on the movable/sliding door.
A and B are compatible with each other:
according to your needs and/or preference, if necessary you can use both short
screws (holes ø6) and long screws (holes ø4.5).
After drilling, clean the door surface and remove any burr. Better treat the door
surface with rust preventive paint.
If you choose short screws, install the threaded inserts with specific pliers.
D
11
ENG