GETTING STARTED (CONT.)
Place the filters back into the air purifier.
3.
The Pre-Filter must be facing outward
and the Activated Carbon Filter must
be facing inward for both filters. Make
sure the pull tabs are visible and facing
inward.
[Figure 1.3]
Replace the rear cover. Twist the cover
4.
lock anticlockwise to secure the cover.
5.
Place your air purifier on a flat, stable
surface with the air outlet facing up.
Leave 38 cm / 15 in of clearance on all
sides of the air purifier.
Connect the AC power adapter to the
6.
air purifier. Plug into an outlet.
Pull tabs facing inward
Figure 1.3
U S I N G YO U R A I R
P U R I F I E R
WARNING: Make sure the air outlet and the
air inlets are not blocked. This may cause
the air purifier to overheat and stop working.
1.
Press the Control Button to turn on the
air purifier. The fan will start on "SLEEP".
Note:
Sleep Mode uses the lowest
•
possible fan speed for a quiet
environment.
•
In Sleep Mode, the display lights
will automatically turn off after 5
seconds. Press the Control Button
again to turn the display lights on
again for 5 seconds.
Optionally, press the Control Button to
2.
change fan speed ("SLEEP", "LOW", and
"HIGH"), and to turn the air purifier off.
Note:
"HIGH" is the loudest fan speed, but
•
cleans air the quickest.
•
For best results, or to address
a specific air quality issue such
as smoke, run the air purifier on
"HIGH" for 15–20 minutes before
using a lower speed.
To effectively clean air, keep
•
windows and doors closed while
the air purifier is on.
EN
7