Switching On And Off - Black+Decker HSM13E1 Manual De Instrucciones

English
Attaching the steam head (Fig. C)
1. Connect the steam mop body to the steam head
the steam head connector
button 13 clicks into place in the the opening
Fig. C
14
13
6
Attaching a cleaning pad - Fig. D
Replacement cleaning pads are available from your
BLACK+DECKER dealer (cat. no. SMP20).
• Place a micro-fiber cleaning pad
'loop' side facing up.
• Press steam mop down onto the cleaning pad. You are
now ready to steam clean and sanitize your floor.
nOTiCE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle tube
9 in the upright position when stationary and make sure the
steam mop is turned off and unplugged when not in use.
Fig. D
Removing a cleaning pad

CAUTION: Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do
not wear slippers or open toed footwear.
1. Return the handle tube
turn the steam mop 'OFF'.
2. Wait until the steam mop cools down (approximately
5 minutes).
3. With suitable shoes on, step on the edge of the cleaning
pad and lift the steam mop away from the cleaning pad
freeing it from the 'hook & loop' fastening.

CAUTION: Always place your steam mop with the
handle tube 9 supported in the upright position
when stationary and make sure the steam mop is
turned off when not in use.
4
5 , ensuring the connection
14
5
7 on the floor with the
6
7
9 to the upright position and
Filling the water tank (Fig. E)

6 via
WARNING: Do not over fill the tank.
nOTE: Do not use chemical cleaners with your steam mop
.
water tank.
nOTE: Fill the water tank with clean tap water.
nOTE: In areas of hard water, the use of distilled water is
recommended.
1. Make sure the steam mop is turned Off and unplugged.
2. Open the water tank access tab
3. Fill the water tank
4. Replace the water tank access tab.
nOTE: Ensure the water tank access tab is firmly secured.
NOTICE: Always empty the water tank after use.
NOTICE: Fill the water tank with clean tap water (Do not
use any additives or chemicals).

WARNING: Your water tank has a 380ml capacity. Do
not over fill the tank.
Fig. E
OPERATION

CAUTION: Never use the steam mop without first
attaching a cleaning pad.
iMPORTAnT: This unit will kill 99.9% of germs when used
in accordance with the instructions in this manual and with
the micro-fiber pad fitted and a continuous run time of 90
seconds.
nOTiCE: Never leave the steam mop in one spot on any
surface for any period of time. Do not store with a wet pad
as this can damage your floor. Always place the steam
mop with the handle tube
stationary and make sure the steam mop is turned off and
unplugged when not in use.
NOTICE: Always empty the water tank after use.

Switching On and Off

It takes approximately 30 seconds for the steam
NOTICE:
mop to heat up.
1. To switch the appliance On, press the On/Off button
2. Press the steam operation button
the pump and the unit will begin to produce steam.
3. To stop steam generation, turn the steam operation
button 2 to Off. This will maintain power to the boiler
for quicker start up.
4. To switch the appliance Off, press the On/Off button
.
3
4 with water.
4
9 in the upright position when
2 . This will operate
3
.
1
1 .