Control Panel - Lamborghini Caloreclima MEGA Serie Manual De Instalación, Uso Y Mantenimiento

CONTROL PANEL

The instrument panel supplied, made from plastic with index of protection IP40, holds the control and safety instruments.
The boiler must be connected to 230V - 50Hz single-phase + earth mains power, in compliance with the following requirements.
- The system must be compliant with the SAFETY STANDARDS IN FORCE.
- Use of a two-pole mains disconnect switch, compliant with the IEC-EN standards (minimum contact opening 3 mm).
- Observe the polarity L (Phase) - N (Neutral).
- Use cables with a minimum cross-section of 1.5 mm
- Refer to the wiring diagrams in this booklet for any operations on the electrical system.
- Connect the appliance to an effective earth system.
- A connection point is provided on the front head for earthing the boiler body.
1 2-stage thermostat, 1
2 Thermometer
3 Main switch + power indicator light
4 System pump switch
5 Burner switch
6 Hour counter
7 Burner lockout indicator light
8 Safety thermostat reset button
9 Space for temperature controller
2 .
1
8
9
st -2 nd flame
- 40 -
2 3 4
7
GENERAL
5
6