Denon Envoi HL Guia Del Usuario página 3

Features
Front Panel
1. IR Transmitter: Hold this up to a receiver to pair.
2. Battery Compartment: Install 2 AA batteries
inside by pulling both sides of the compartment
(with the arrows pointing to you) to open. Make
sure the polarities of the batteries (+ and –) are
installed correct.
Top Panel
1. Microphone Input: When using the
included lavalier
microphones, input the connector
into the input and screw in the
connector clockwise to secure the
cable.
Note: Other cables with TS, TRS, or TRRS connectors can be used,
though they may not be able to lock in place.
2. Gain Selector: Use this switch to set the gain of the audio input to Mic
level, 0 dB, or -10 dB.
3. Power: Adjust this switch to turn the transmitter ON (transmitter and
audio are on), STANBY (transmitter is in standby mode, powered on but
audio is muted), or OFF. The LED above the power switch will illuminate
when the power is on.
4. Antenna: This is used to transmit the audio signal to a receiver.
Rear Panel
1. Belt Clip: Attach the transmitter bodypack to your
clothing beltline or hip area.
1 2 3 4
or headset
1
1
1 2
0dB
INPUT MIC -10dB
2 3 4
1
IR
2
3 4
STANBY
ANT
ON OFF
1
1
3