Denon Envoi HL Guia Del Usuario página 4

Operation
Wireless Mic Setup
To use a wireless mic, follow these setup steps:
1. Ensure 2 new AA alkaline batteries are installed in the Envoi HL
Transmitter.
2. Pair the mic to a receiver. Both the Denon Professional Envoi and the
Marantz Professional Voice Rover can be used as a receiver.
a. Turn on the Envoi HL Transmitter and the receiver.
b. Select the UHF channel on the receiver that you want to use with
the best reception.
c. Place the IR sensor (found above the battery compartment) near
the receiver's IR LED and press the ASC button once on the
receiver. Wait for about 3 seconds until the IR LED stops flashing.
When it finds an interference-free channel the RF LED will
illuminate on the receiver showing the mic is matched to that
channel.
3. To connect the mic to Envoi HL Transmitter, insert the connector into the
input and screw in the connector clockwise to lock it. To unplug, reverse
this process.
• If
using
(76 mm) from your mouth, but away from the wind path to avoid
breath and "pop" sounds.
• If using a lavalier mic, clip this on your shirt at chest-height, up to
6" (152 mm) away from your mouth.
4. Adjust the volume on the UHF receiver. If you are using the Denon
Professional Envoi or Marantz Professional Voice Rover, turn the Power-
Vol knob clockwise on the UHF receiver panel.
5. As you speak, watch the AF indicator on the receiver to make sure a
signal is being received. The Gain Selector on the Envoi HL Transmitter
can be adjusted for more or less output signal.
4
a headset mic, position the mic about 3"