Troubleshooting - HQ-Power PROCD330 Manual Del Usuario

l. Programmed Play
o Press the PROGRAM button. The CD player will enter the program mode and the CD will stop rotating.
o Select the desired track using the
will be added to the program sequence.
o Repeat the above step if necessary. You can program max. 20 tracks.
o Press the PLAY/PAUSE button to start playing the programmed sequence. The CD player will start with the first
selection. Press the PROGRAM button to stop the playing.
o Hold the PROGRAM button pressed for 3 seconds to erase the content of the programmed sequence.
m. Loop Play
o Press the A button to set the beginning of the loop.
o Press the B button to determine the end of the loop and to start the playing of the loop.
o To cancel the loop, press the B button again.
o Press the RELOOP button to start the last saved loop.
o To reset the loop, cancel the loop and then repeat the first two steps.
n. Repeat Play
o Press the REPEAT button once to repeat the current playing track.
o Press the REPEAT button again to repeat all the tracks.
o Press the REPEAT button once more to cancel.
o. Relay
o Insert a CD in both disc holders.
o Put both sides in single mode.
o Press the PLAY/PAUSE button for CD 1. The CD player will play one track from CD 1 before switching over to CD
2. The CD player will now play one track from CD 2, switch back to CD 1 and play the next track of that disc. The
CD player will alternatively play one track from CD 1 and CD 2 until all tracks have been played. You can also
program the sequence of the tracks to be played, keeping in mind to choose an equal number of tracks for both
CDs.
o When you put both sides in continue mode, the CD player will switch over to the next CD after having played all
the tracks of the first.

8. Troubleshooting

Problem Cause
No power - The power cord isn't connected.
- The fuse is melting.
No sound - Audio cable isn't well connected.
- Incorrect source selection.
- Incorrect audio setup.
Unable to play - No disc loaded.
- Defective disc.
- Disc is loaded upside down.
- Dirty disc.
- Parental control activated.
Key malfunction - Power wave or other static interference.
PROCD330_v4
or the button. Press the PROGRAM button again. The selected track
10
Solution
- Connect the power cord properly.
- Replace the fuse with a fuse of the same type
and rating
- Connect the cable properly.
- Switch to the proper source.
- Select the suitable audio setup.
- Load a disc.
- Replace the disc.
- Load the disc properly.
- Clean the disc.
- Deactivate the parental control or change
setup.
- Switch off the player, switch on again.
VELLEMAN