Hardware Installation - D-Link ShareCenter Pro 1200 Guia De Instalacion

Follow the instructions below to install a hard drive, connect to the network and power
on the ShareCenter. Open the shipping carton for the ShareCenter and carefully remove
and unwrap its contents. Follow the instructions below to setup the ShareCenter. If this
is the irst time using the ShareCenter or if a new hard disk is installed, use the Easy
Search utility located on the Installation CD and follow the instructions for setting up,
coniguring and formatting the new drive.
To install ShareCenter on your local network, refer to the steps below:
1. Put a 3.5" SATA hard drive into a drive tray and use
screws to fasten the hard drive with the tray. There are
four holes for fastening the screws. Two holes are circled
in red in the image, and the other two holes are on the
other side of the drive tray.
2. Open the faceplate to access the drive bays.
3. Insert the tray into a bay.
D-Link DNS-1200-05 Quick Installation Guide

3. Hardware Installation

5