Morphy Richards 102004 Manual De Instrucciones página 3

KT102004MEE Rev2.qxp_Morphy Richards 05/11/2014 10:59 Page 3
A
2
1
3
5
B
„
g
Getting the best from your new kettle...
Empty the water out of the kettle after first boiling
To clean away any deposits that are left in the kettle after the
manufacturing process.
Descale as appropriate for the hardness of the water in
your area
It is important to descale as the performance of the kettle and
auto switch-off will be impaired.
Safety first
Always pour water slowly and carefully to prevent the splashing
of scalding water.
Fast boil kettles perform differently
If your kettle is a fast boil model, it may sound louder during
boiling, and switch off suddenly with no after noise - this is
normal.
Treating scalds
• Run cold water over the affected area immediately. Do not stop
to remove clothing, get medical help quickly.
Features
A
⁄ Lid
¤ Lid knob
‹ Spout filter
› 360°connector
fi Cordless base unit
fl Cord storage
‡ On/off switch
· Power on neon
‚ Water level indicator
„ Whistle on/off switch (Depends upon model)
3
9
8 7
9
6
7
4
6
2
1
3
8 5
Using
Filling the kettle
1 Wherever possible fill through the spout, as this helps to free the
filter from limescale build-up.
• The integrated water level indicator allows you to easily see the
amount of water in the kettle.
• Always ensure that the level of water in the kettle is filled to at
least the minimum level shown on the water gauge. Should your
kettle not have a water gauge, always ensure that the element is
covered.
• Boil only as much water as you need as this saves electricity.
2 Place the kettle on the base unit, ensuring the kettle locates on
to the 360° connector.
• The 360° connector allows the kettle to be located at any
position. - ideal for left and right handed users and for
convenient positioning on the worktop.
3 Plug in and switch on at the wall socket.
4 Switch the kettle on. The 'power on' neon will light up.
5 When the water boils the kettle will switch off automatically.
• If you are using the kettle for the first time, pour away the boiled
water and refill.
6 Lift the kettle from the base unit by the handle ensuring you hold
the kettle level.
• To re-boil, switch to ON again. If the kettle has just switched off
wait a minute or so before switching it back on again.
• If you do not put in enough water, or switch on the kettle when it
is empty, the safety cut-out will switch off the power
automatically. If this happens, refill and wait a few minutes for
the element to cool, then use as normal.
3
4
7
6
g
3