Install The Hardware; Mount The Video Encoder; Connect The Cables - Axis Q7404 Guia De Instalacion

AXIS Q7404 Installation Guide

Install the hardware

!
IMPORTANT! - The casing of the AXIS Q7404 is not approved for outdoor use - the
product may only be installed in indoor environments.

Mount the video encoder

The video encoder is supplied with a mounting kit containing screws and plugs for mounting the
video encoder to a concrete wall:
1. Place the video encoder against the wall, and mark the location of the four mounting holes (see
page 4) through which the video encoder will be attached.
2. Remove the video encoder and drill the four mounting holes.
3. Insert the wall plugs into the wall, position the video encoder, and attach it to the wall using
the screws provided.
The supplied protective pads can be used to avoid scratching the surface on which the video
encoder is placed. Punch out the pads and apply them to the underside of the video encoder.

Connect the cables

1. Connect the encoder to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 14 for
information on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the cameras to the video inputs.
5. Connect the supplied indoor power adapter or an external power supply.
6. Check that the indicator LED:s indicate the correct conditions. See the table on page 17 for
further details.
Page 5