Securing Bsm-2 Module; Wiring; General - Simrad BSM-2 Manual De Instrucciones

Securing BSM-2 module

Mount the BSM-2 on a vertical surface with the power
and transducer cable entries exiting downwards.
Fasten the BSM-2 by using the 4 stainless steel self
tapping screws included with the unit.

Wiring

General

The power and the transducer
cables connect with screw
terminals inside the BSM-2
unit. Refer wiring diagram and
connection details on the following
pages.
The BSM-2 contains high voltages and specialized
parts; the operator should never remove the
module's cover without removing the power
connection.
Removing the transducer cable from the BSM-2
while the module is powered on can cause sparks.
Remove the transducer cables only after the
module has been disconnected from its power
source.
8 | BSM-2 Installation manual
BSM-2_IM_988-0170-09_A.indb 8 2/14/2011 2:52:21 PM