Special Wash Cycles And Options - Hotpoint Ariston LFF 8M121 Instrucciones De Uso

Special wash cycles and Options

Notes:
EN
Optimum performance levels when using the "Fast" and "Express
30'" cycles can be achieved by respecting the specified number
of place settings.
To reduce consumption, only run the dishwasher when
it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Delayed start
It is possible to delay the start time of the cycle for a
period of time between 1 and 24 hours:
1. Select the desired wash cycle and any other options required,
press the DELAYED START button. The relevant symbol starts
flashing. Use the buttons + and - to select when the wash cycle
will start (h01, h02 etc.)
2. Confirm with the START/PAUSE button. The symbol stops
flashing and the countdown begins.
3. Once this time has elapsed, the DELAYED START symbol
switches off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text OFF appears.
The Delayed Start function cannot be set once a wash cycle
has been started.
Short Time option
This option can be used to reduce the duration of the
main wash cycles while maintaining the same washing and
drying performance levels.
After selecting the wash cycle, press the Short Time option
button;
To deselect the option, press the same button again.
*
Only available in selected models.
28
(see Table of wash cycles)
, the
Extra drying
To improve the dryness level of the crockery, press
the EXTRA DRYING button and the symbol will light up. If it is
pressed again, the option will be deselected.
A higher temperature during the final rinsing and a longer drying
phase improve the dryness level.
The EXTRA DRYING option increases the duration of the
wash cycle.
Multi-functional tablets (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol
will light up. If the button is pressed again, the option will be
deselected.
The "Multi-functional tablets" option results in a longer
wash cycle.
The use of tablets is only recommended for models
having this option and it is not recommended with wash
cycles which do not specify the use of multi-functional
tablets.
Zone Wash
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash cycle and
then press the ZONE WASH button: the selected rack lights
up and the wash cycle starts in the selected rack only. Press
the button again to deselect the option.
The option is available with the following wash cycles:
Intensive and Normal.
Select the option and the Intensive cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans,
dishes with heavy encrustation or difficult-to-clean crockery
(grater, vegetable mill, dirty cutlery). The spraying pressure is
stronger and the washing temperature higher, thus ensuring
optimum handling of stubborn stains.
Select the option and the Normal cycle to start the SAVING
ZONE washing. This function makes it possible to reduce
energy consumption. Cycle duration might change.
Remember to load the crockery in the selected rack only