Special Wash Cycles And Options - Hotpoint Ariston LSB 7M116 Manual De Instrucciones

Special wash cycles and Options

Notes:
Optimum performance levels when using the "Fast" and "Express
40'" cycles can be achieved by respecting the specified number
of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options whic are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
*
Delayed start
It is possible to delay the start time of the wash cycle by 3,
6 or 9 hours:
1: After selecting the desired wash cycle and any other
options, press the DELAYED START button: the indicator
light will go on.
2: Select the desired delay time by pressing the Delayed Start
button repeatedly. The indicator lights for the wash phase
(3 hours), drying phase (6 hours) and end phase (9 hours)
will switch on in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light switches off.
3. After the selection process, the countdown will begin if
the Start/Pause button is pressed. The selected delay-period
indicator light flashes and the Start/Pause button stops
flashing (fixed light.)
4. Once this time has elapsed, the DELAYED START indicator
light switches off and the wash cycle begins.
The Delayed Start function cannot be set once the wash
has been started.
*
Only available in selected models.
(see Table of wash cycles)
, the
*
Half load
If there are not many dishes to be washed, a half load cycle
may be used in order to save water, electricity and detergent.
Select the wash cycle and press the HALF LOAD button; the
indicator light will go on.
Press the HALF LOAD button again to deselect this option.
Remember to halve the amount of detergent.
It is better to use powder detergent.
EN
11