60
D
G
ISPLAY
UIDE
Program display
Frequency display
Pulse width
display
Intensity,
channel 1
When the unit is switched on, all readouts are active for a short ti-
me before the unit switches to standby (wait) mode.
Pause
Function check
Treatment time
Intensity,
channel 2
P
S
ROGRAM
ELECTION
Preset programs P-01 to P-11 and memory function
After attaching the electrodes, press the "ON/OFF" button to
1.
switch on the unit.
Keep pressing the "Program" button until one of the preset pro-
2.
grams (P-01 to P-11) is shown on the display.
Press the "Set" button. The time will flash on the display, " "
3.
for minutes and " `` " for seconds. Use the "+" or "–" buttons
to enter the desired treatment duration (20 minutes to 2 hours)
in steps of ten minutes.
Press the "Select" button 2 times. The intensity display "CH1"
4.
will start to flash. Use the "+" or "–" buttons to enter the desi-
red value (from 1 to 50). Setting the intensity will simulta-
neously start the unit. In the top right of the display, the clock
symbol will begin to flash. Press the "Select" button once mo-
re. The intensity display "CH2" will start to flash. Once again,
...