Remote Level Control (S4.1000.1D Only); Using Passive Crossovers - Lightning Audio STRIVE S4.200.2 Instalación Y Operación

Installation
REMOTE LEVEL CONTROL
(only usable in LP Low Pass mode)
(Model S4.1000.1D Only)
Mounting and installation
1. Find a location, either under the dash or near
the center console, that gives easy access to
the remote.
2. Using the screws supplied, install the mounting
clip with the tabs towards the back.
3. Route the cable for the remote and connect to
both the remote and amplifier.
4. Slip the remote onto the mounting clip until it
snaps into place.

USING PASSIVE CROSSOVERS

A passive crossover is a circuit that
uses capacitors and/or coils and is
placed on speaker leads between the
amplifier and speaker. The crossover
delegates a specific range of
frequencies to the speaker for
optimum driver performance. A
crossover network can perform one of
three functions: High-Pass
(capacitors), Low-Pass (inductors or
coils) and Bandpass (combination of
capacitor and coil).
The most commonly used passive
crossover networks are 6dB/octave
systems. These are easy to construct
and require one component per filter.
Placing this filter in series with the
circuit will reduce power to the
speaker by 6dB/octave above or
below the crossover point depending
on whether it is a high-pass or low-
pass filter. More complex systems
such as 12dB/octave or 18dB/octave
can cause impedance problems if not
professionally designed.
Passive crossovers are directly
dependent upon the speaker's
impedance and component value for
accuracy. When passive crossover
components are used in multiple
speaker systems, the crossover's
effect on the overall impedance should
be taken into consideration along with
the speaker's impedance when
determining amplifier loads.
L
6dB/Octave Low-Pass
Speaker Impedance
Freq.
2 OHMS
Hertz
L C
80 4.1mH 1000µF
100 3.1mH 800µF
130 2.4mH 600µF
200 1.6mH 400µF
260 1.2mH 300µF
400 .8mH 200µF
600 .5mH 136µF
800 .41mH 100µF
1000 .31mH 78µF
1200 .25mH 66µF
1800 .16mH 44µF
4000 .08mH 20µF
6000 51mH 14µF
9000 34mH 9.5µF
12000 25mH 6.6µF
L = Low-Pass (Inductor)
C = High-Pass (Capacitor)
For more information, see your Authorized Lightning
C
6dB/Octave High-Pass
4 OHMS
L C
8.2mH 500µF
6.2mH 400µF
4.7mH 300µF
3.3mH 200µF
2.4mH 150µF
1.6mH 100µF
1.0mH 68µF
.82mH 50µF
.62mH 39µF
.51mH 33µF
.33mH 22µF
.16mH 10µF
.10mH 6.8µF
68mH 4.7µF
51mH 3.3µF 100mH
Audio Dealer.
Mounting
Clip
8 OHMS
L C
16mH 250µF
12mH 200µF
10mH 150µF
6.8mH 100µF
4.7mH 75µF
3.3mH 50µF
2.0mH 33µF
1.6mH 26µF
1.2mH 20µF
1.0mH 16µF
.68mH 10µF
.33mH 5µF
.20mH 3.3µF
.15mH 2.2µF
1.6µF
9