Intended Use; Instructions Before Installation - Dometic Heki 4 Plus Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57

Intended use

5
Intended use
The Heki 4 Plus roof light (item no. 9104100294) is suitable for installing in
motor homes or caravans.
The two lamps cannot be dimmed.
The maximum permissible speed is 100 km/h, as noise or damage could
occur depending on the vehicle design or installation position. The spoilers
available as an optional extra enable a speed of 130 km/h.
6

Instructions before installation

➤ Before installation, check the roof thickness of your vehicle. Consult the
vehicle manufacturer if you have any questions.
➤ Make sure that a 12 V power supply line is available for the drive (rated
power 21 W), as well as for the Heki 4 Plus (2 x 8 W) lighting in the
vehicle.
➤ Make sure that the power supply line is suitably arranged and protected.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts),
cables and cabinets in the vehicle interior must not get damaged when
sawing the hole.
– Sufficient space needs to be available for installing the inner and outer
frames.
– Only fit the roof light on flat and parallel interior and exterior roof areas
with a maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
– You can fit the roof light sideways (hinge-side at front in direction of
travel) or lengthways (hinge-side on left or right in direction of travel).
6.1
Pressing out the hole
See fig. 2
22
Heki 4 Plus
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido