Dometic Heki 4 Plus Manual De Instrucciones página 29

Installing the Heki 4 Plus
Preparing the lamps for installing on the long side
➤ Insert the holders in the openings provided on the long side (D).
➤ Lay and attach the wiring harness on the back again.
➤ Connect the cables (E).
See fig. c
NOTICE!
A
Make sure that the power supply lines from the vehicle and from the
outer frame are inserted in the inner frame opening and do not get
stuck.
➤ Place the inner frame on the outer frame and fasten it with the fastening
screws  2.5 x 12 mm in the 16 mounting supports.
To do this, use the small holes in the mounting supports.
Only fasten the screws slightly by hand.
➤ Check that the roller blinds can move freely.
If they do not, then loosen the screws slightly.
See fig. d (cross side installation)/fig. b (long side installation)
➤ Insert the lamps into the holders (F).
26
Heki 4 Plus
EN