Check Installation - GE IM-5D Manual Del Propietario E Instrucciones De Instalación

INSTALLING THE ICEMAKER (Continued)
PLUG IN THE ICEMAKER
5
Place icemaker and fill cup on top of lower
basket contents, or ice bucket (for support),
the six pin connector first and then the four
pin connector.
4-Pin Connector
MOUNT THE ICEMAKER
6
slots on the side of the icemaker with the
mounting pins
Screw
in the freezer
Hole
wall. Slide the
icemaker back
so the fill tube
on the top
wall fits inside
the fill cup
opening.
Mounting Pins
Make sure:
- The connector plugs are still firmly in the
sockets.
- The fill tube extends into the fill cup opening
at the back of the icemaker.
- The icemaker is level.
Check the wiring to make sure the ice maker
is plugged in correctly.
49-60740-4
Installation Instructions
6-Pin Connector
4-Pin Connector
6-Pin Connector
Fill Tube
Fill Cup
Mounting Screw

CHECK INSTALLATION

7
Push the icemaker back toward the rear of
the cabinet so the mounting screw hole in the
icemaker flange aligns with the mounting hole
in the freezer side wall, making sure wires are
not hanging outside of wire housing.
kit into the hole in
the flange of the
icemaker.
REMOVE THE ICE BUCKET
8
For non-counter depth modles:
bucket cover onto the ice bucket by snapping
pins into holes at the back of the ice bucket.
NOTE: Kit comes with two ice buckets. Counter
bucket (in models with "Y" in model number such
as GYE) for additional ice storage or it can be
recycled.
Hex Head
Mounting Screw
Cover
(Front)
7