Assembly Instructions; Short Shaft Models; Long Shaft Models; Operation - Little Wonder 2300 Manual De Instrucciones

Assembly Instructions

WARNING
BLADES ARE EXTREMELY SHARP! TO AVOID
INJURY WHEN UNPACKING THE HEDGE TRIMMER,
DO NOT GRASP THE BLADES.
A. Short Shaft Models
1. Your Little Wonder hedge trimmer has been mostly
assembled for you at the factory. No tools are required to
complete the assembly.
2. Pull the spring pin up on the cutter head assembly and
slide it onto the shaft lining up the drive shaft.
3. When the drive shaft is properly aligned, the spring pin of
the cutter head will drop into the hole on the shaft.
4. Pull on the gearbox to make sure the pin is engaged with
the hole on the shaft. Failure to engage the gearbox to the
shaft completely could cause damage to your hedge
trimmer.
5 Tighten the round knob.
6. The handles have been assembled at the factory and set
according to the average size man. The loop handle can be
adjusted to the operator's preference by simply loosening
the screws and sliding them up or down the shaft.
Step 1
Spring Pin
Knob
Front View
Step 2
6.
– DANGER
Shaft
Hole
WARNING
IMPROPER ASSEMBLY OF THIS TRIMMER CAN
RESULT IN SERIOUS INJURY. MAKE SURE TO
FOLLOW ALL INSTRUCTIONS CAREFULLY.
IF YOU HAVE ANY QUESTIONS, CONTACT YOUR
LOCAL DEALER OR OUR FACTORY AT (215) 357-5110.
B. Long Shaft Models
1. Your Little Wonder hedge trimmer has been mostly
assembled for you at the factory. No tools are required to
complete the assembly.
2. Pull the spring pin up on the 24" shaft assembly and slide
it onto the shaft lining up the drive shaft.
3. When the drive shaft is properly aligned, the spring pin of
the 24" shaft will drop into the hole on the 36" shaft.
4. Pull the spring pin up on the cutter head assembly and
slide it onto the 24" shaft lining up the drive shaft.
5. When the drive shaft is properly aligned, the spring pin of
the cutter head will drop into the hole on the shaft.
6. Pull on the gearbox to make sure the pin is engaged with
the hole on the shaft. Failure to engage the gearbox to the
shaft completely could cause damage to your hedge
trimmer.
7. Tighten the round knob.
8. The handles have been assembled at the factory and set
according to the average size man. The loop handle can be
adjusted to the operator's preference by simply loosening
the screws and sliding them up or down the shaft.

Operation

WARNING
THE OPERATOR OF THIS HEDGE TRIMMER
IS RESPONSIBLE FOR ACCIDENTS OR
HAZARDS OCCURRING TO HIMSELF, OTHER
PEOPLE OR THEIR PROPERTY.
– DANGER
– DANGER