Klarstein Kristall Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
16
Buttons and Indicator Lights
The indicator of POWER will flash after plugged in, press POWER and then
the machine enters standby state accompanying indicator lighting. During
operation, pressing this button, the machine will return to standby state.
Pause and Start: After choose the menu, press this key, and start to work.
This button is for selecting the size of ice. When you select the desired size,
corresponding indicator of Speedy or Regular will be on.
When the indicator of this button turns to red, it means insufficient water to
water reservoir, you need to add enough water and press POWER button to
restart the machine.
When the ice is reach to the max storage capacity, the indicator of this button
will light on, and the machine will stop working. What you need to do is
pouring out the ice, if the position of ice is lower than the position of ice board,
the machine will restart automatically.
Operation
1
Open the cover, and add water to reservoir. NOTE: There is a hole on the water
box, which is the maximum water level, water adding do not exceed it. If the water
exceed, it will drain out. Suggest the water add under the hole, then put the water
box into proper position, and cover it.
2
Connect the power, press the POWER key and then the machine enters standby
state.
3
Select the desired ice size, the default size of machine is large one.
4
Press START key to start work.
Important Notes
• The water poured into water reservoir should be lower than the water reservoir's
MAX position. When water volume goes beyond the max, please open the bottom
water drain plug to drain the spare water out. Then close the transparent lid.
• Please select the small ice when ambient temperature is below 15°C. When the
ambient temperature is higher than 25°C, Large ice cube sizes are recommended.
• When the ice basket is full please remove the ice immediately, Do not allow the ice
Basket to overfill. When the ice basket is full enough, you can take out the up water
box, and take out a part of ice, you can take out the ice basket.
• Before making ice, do put the ice basket in the ice maker.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

10031891

Tabla de contenido