Rack Mounting A Single Unit; Rack Mounting Two Units Sice By Side - AKG HEARO 999 AUDIOSPHERE Modo De Empleo

3 Audio and Power Connections
3.4 Rack Mounting a
Single Unit
Refer to fig. 1b.
Refer to fig. 1c.
Refer to fig. 1d.
3.5 Rack Mounting Two
Units Side by Side
20
1. Unscrew the two fixing screws on the bottom of each side panel support.
2. Remove the two side panel supports.
3. Place a clamping slide (19) on each rack ear (20), checking that the pegs on the clam-
ping slides (19) engage in the fixing holes on the rack ears (20).
4. Slide the clamping slides (19) and rack ears (20) into the fixing rails on both sides of the
unit from rear to front.
5. Tighten the two Phillips screws in the clamping slides (19) CW to fix the rack ears (20) on
the unit.
6. Use the supplied screws to fix the supplied blank (21) panel to the left or right rack
ear (20).
7. Use the supplied installation screws to install the unit in the rack.
1. Unscrew the two fixing screws on the bottom of each side panel support.
2. Remove the two side panel supports.
3. Fix one rack ear (20) to the outside panel of each unit referring to steps 1 through 3
above.
4. Insert a clamping slide (19) with no rack ear (20) into the fixing rails on the INSIDE PANEL
of one unit.
5. Insert the unit with the clamping slide (19) on its inside panel into the fixing rails on the
inside panel of the other unit.
6. Tighten the two Phillips screws in the inside clamping slide (19) CW to connect the two
units.
7. Use the supplied installation screws to install the units in the rack.