Celestron 47005 Manual De Instrucciones

Personal Weather Station with
Wireless Remote Sensor
Model # 47005
Thank you for purchasing this Celestron personal weather
station. Please read the instructions prior to using it and we hope
you will have many years of pleasure with it.
Set Up Power for the Receiver
For optimum performance, please place the Receiver away from metal and other sources of
interference such as mobile phones, TVs, computers, appliances, etc. If the Receiver stops showing
the display or dims, replace the batteries.
The Receiver can be put on a table, desk, or other flat surface or it can (by using a
hanger cut out on the rear of the Receiver) be hung on a wall or other location. For
using on a flat surface the small base piece is to be inserted at the bottom of the
Receiver by pushing the two protruded pieces into the open slots on the bottom of
the Receiver until secure. The correct position of the base is shown in the image to
the right.
Set Up the Power & Make Settings for the Wireless Remote Sensor
Remove the four small screws (center right image) from the rear door of the sensor with a small
screwdriver (remove the bracket first). Insert two AAA batteries (user supplied) as indicated in the
sensor (see right image). Set the switch to "1" (for Channel 1), push/toggle the button so readings will
be shown in "C" (Centigrade) or "F" (Fahrenheit). Then push the button "TX" and hold it a couple of
seconds which will transmit the RF signal from the Sensor to the Receiver. The Sensor itself will
display the outside temperature and humidity (see left image). Replace the rear door of the sensor by
installing the four small screws to hold it in place.
The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to
communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely (hanger
part on left of center image) to any surface that is secure or it can stand by itself (if in an area without
wind, etc. by using the included stand bracket (center left image).
Open the battery compartment door on the rear of
the Receiver. Then insert two AA batteries (user
supplied) with polarity as indicated in the battery
compartment. After installation, put the battery
compartment door back on. If battery power is
low, a low battery icon will be shown on the
LCD display alerting you to change the batteries.