Celestron 47005 Manual De Instrucciones página 3

The pressure history bar displays the moving atmospheric pressure history of the past 12 hours
which allows for forecasting. To view air pressure history for the past 12 hours, press the "hist"
button to select and view how many hours (repeatedly press the "hist" button).
The respective values can only be available after the barometer recorded the pressure date in the
past 12 hours. The spectrum bar chart indicates pressure changes of the past 1, 2, 3, 6, and 12
hours and is shown for a range of -0.24 to +0.24 in/Hg and -8 to +8 mb/hPa.
Temperature & Humidity Alert – press the "alert" button on the rear of the Receiver to turn
the alert on or off. Press and hold the "alert" button to enter the setup mode. The indoor and
outdoor temperature and humidity upper and lower limits can be set by using the "+" and "-"
buttons and pressing "alert" to confirm each setting. When either the temperature or humidity
alert values have been reached while the alert is activated, the respective values will flash and
the alarm will sound --press "alert" to stop the alarm.
Alarm Setting – Press the "alarm" button to toggle between alarm 1 and alarm 2, and normal
time. In "alarm 1" or "alarm 2" press and hold to set the alarm time by using the "+" and "-"
buttons to set the hour and minute and press the "alarm" button to confirm each. To turn either
alarm on or off, toggle the "+" button and you will see a bell icon for alarm 1 or alarm 2 or both
or none.
Snooze/Light – when the alarm goes off, press the "snooze" button to go into snooze mode and
the alarm will go off again after 9 minutes and then continue to do this every 9 minutes. To stop
the snooze, press the "alarm" button. To enable the backlight for a moment just push the
"snooze/light" button in normal mode and for having the light on for a longer time keep holding
down the button.
Channel – if your Sensor is set correctly to Channel 1, then a small icon to the left of outdoor
temperature display will show a "1" in a box. If you do not have an outdoor temperature and
humidity display, make sure that the "1" is displayed and if not (shows a 2 or 3), then push the
"CH" button until it shows the "1".
Specifications:
Indoor Temperature Range = 0º to +50º C (+ 32º to + 122º F)
Remote Sensor Temperature Range = -20º to + 60º C (-4º to + 140º F)
Indoor/Outdoor Humidity Range = 20% to 95% Relative Humidity
Resolution = ± .5º C (± 1.5º F) for temperature & ± 1.5% humidity
Altimeter = 328 ft to 8202 ft (100 m to 2500 m)
Barometer = 26.80 to 31.01 in/Hg (900 to 1050 mb/hPa)
Clock = digital quartz
Transmission = RF433 MHz
Dimensions = Receiver – 4.0" x 1.0" x 10.0" (102mmx25mmx254mm) Sensor - 2.5" x 1.0" x
3.6" (63mm x 25mm x 91 mm)
Weight = Receiver - 14oz/397g
2835 Columbia St.
Torrance, California 90503 U.S.A.
www.celestron.com
Printed in China 0110
Sensor - 3oz/85g
RoHS