Night Light - Bionaire BU7500 Manual De Instrucciones

WE reccomend that you do not use your humidifier in an
area where the humidity level exceeds 55%.
DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. The unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
CAUTION: In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility.
ASSEMBLY INSTRUCTIONS
1. Be sure your humidifier is switched off and
disconnected from the wall outlet.
2. Install the Mist chamber (D) into the Base (G).
3. IMPORTANT: To eliminate the emission of minerals
from the water, it is recommended that the Water Filter
is always used.
4. Place the water tank (C) into the body.
IMPORTANT: Make sure the water tank as well as
the inside of the base are clean before using the
appliance and after storing for a long time.
5. Ensure the humidifier is level. If the humidifier is not
level always turn the power off before handling it.
OPERATING INSTRUCTIONS
Filling the Water Tank
NOTE: Always switch off and unplug your humidifier before
filling the water tank. The water you put into the water tank
should be clean and not be over 40°C (cold boiled water or
demineralised water are recommended).
1. Remove the lid and lift the water tank out of the base.
2. Unscrew the filter/water tank cap (E and F).
3. Fill the tank with clean water to the MAX mark then
screw the filter/water tank cap back tightly onto the
tank.
4. Put the water tank back into the base.
5. Fit the Lid (B) and Mist outlet (A).
Switching the Unit On and Off
1. Plug the unit into the mains supply socket.
2. Press the On/Off button (V). The LCD display (H) will
light up white and the on/off button and Auto button will
light up blue.
3. By default, your humidifier will start in Auto mode. Note
that it will take up to 5 minutes before auto mode will
function normally and your humidifier may produce
mist during this time even though the room humidity is
higher than 55%. When the room humidity falls below
53% your humidifier will operate normally.
NOTES: Your humidifier has a memory and will remember
the previous settings after it has been turned off. If the unit
has been unplugged however, any previous settings will be
lost and the unit will default to Auto mode when switched
on again.
HUMIDIFIER SETTINGS
Your humidifier has a built-in room humidity indicator (K)
ideal for precise and continuous humidity level monitoring.
If your humidifier is in Auto mode, press the Auto button to
switch it into manual mode. Once in manual mode, the Set
Humidity button (S) will light up. Press the Set Humidity
button until the desired humidity level is shown by the
Set humidity indicator (L). The humidity can be selected
from 40% to 70% in 5% steps or Continuous. To turn your
humidifier to continuous mode, select Cn.
Your humidifier will operate until the set humidity level is
reached. Your humidifier will resume operation when the
humidity level in the room falls below the set level.
Mist Settings
Your humidifier has three mist levels selected by pressing
the Mist level button (R). The levels are shown by the bars
in the Mist level display (O).
Auto Mode
The Auto mode sets your humidifier to operate at a preset
level of 55%. Press the Auto button (Q) to select the auto
mode. Press the Auto button again to exit auto mode.
Warm Mist
The Warm mist button (P) changes the mist temperature
from cool to warm. NOTE: It can take approximately 30
minutes for the mist to change temperature. The Warm Mist
button will not function if the unit is not producing mist.
Timer
The timer allows your humidifer to operate for four pre-set
times: 2, 4, 8 or 12 hours. Each press of the Timer button
(U) will select 2, 4, 8 or 12 hours. When the timer is in
operation, the LCD display will show the clock icon and the
time period selected (N).

Night Light

The night light (I) can be switched on or off using the Night
light button (T).
Auto Safety Shut Off
Your humidifier has a built in safety device When the water
level in the water tank is low, the unit will beep several times
and the Water tank low icon (M) will show. Refill the tank as
described in the section Filling the Water Tank. Do not
overfill. The unit will enter standby mode after 1 minute if
the water tank is not refilled.
WATER FILTER MAINTENANCE
The water filter is used to remove any minerals from the
mist. The filter life is determined by the average daily use
of your humidifier and the water hardness in your area. The
harder the water, the greater the amount of minerals in the
water and the more often you will need to replace the filter.
It is strongly recommended that the filter is replaced every 2
months, (depending on use), or when white dust is emitted
from your humidifier.
1. Switch off your humidifier and disconnect it from the
mains supply socket. Remove the lid (B) and lift out
the water tank (C).
3