Campbell Hausfeld WG3080 Manual De Instrucciones De Operación Y Lista De Partes página 8

Operating Instructions and Parts Manual
Maintenance
Disconnect power supply and turn machine
off before inspecting or servicing any
components. Keep wire compartment cover closed at all times
unless wire needs to be changed.
BeFore eVery use:
1. Check condition of weld cables and immediately repair or
replace any cables with damaged insulation.
2. Check condition of power cord and immediately repair or
replace any cord if damaged.
3. Inspect the condition of the torch contact tip and nozzle.
Remove any weld slag. Replace torch contact tip or nozzle if
damaged.
Do not operate this welding machine with
cracked or missing insulation on welding
cables, torch or power cord.
eVery 3 montHs:
1. Replace any unreadable safety labels on the welder.
2. Use compressed air to blow all dust and lint from ventilation
openings.
3. Clean wire groove on drive roller. Remove drive roller and
use a small wire brush to clean. Replace if worn or damaged.
ConsumaBle and wear parts
The following parts require replacement:
• Wire feed drive roller
• Wire guide
• Torch liner
• Nozzle/contact tips
• Wire - This welder will accept either 4 in. or 8 in. diameter
spools. Flux-Cored welding wire is susceptible to moisture
and oxidizes over time, so it is important to select a spool
size that will be used within approximately 6 months. For
mild steel welding, AWS ER70S6 solid wire or AWS E71T-GS
Flux-Cored wire is recommended.
CHanging wire sizes
This welder is setup for .030 in. (0.8 mm) wire. If a different wire
size is used, the wire feed drive roller and contact tip may need
changing. There are two grooves in the drive roller. The small
groove is for .024 in. (0.6 mm) MIG wire and the large groove is
for .030 - .035 in. (0.8 - 0.9 mm) flux core and MIG wire. Rotate
the tension knob down and swing arm up and flip the drive roller
to choose the correct groove. Optional drive rollers for other
wire sizes are available (See parts breakdown). The contact tip
should also match the wire diameter used. The tip diameter is
marked on the contact tip in inches and/or millimeters.
8
supply CaBle replaCement
1. Verify that welder is OFF and power cord disconnected.
2. Remove welder side panel to expose switches.
3. Disconnect the power cord leads per the diagram inside
the unit.
4. Disconnect the ground wire connected to welder base.
5. Loosen the cord strain relief screws and pull cord out of
strain relief.
6. Install new cord in reverse order per the diagram inside
the unit.
www.campbellhausfeld.com