NuTone PUREPOWER Serie Guia Del Usuario página 11

TROUBLESHOOTING GUIDE (
P P
ROBLEMS
2. Power • Defective
unit does
not start
• Power unit internal
or stops
suddenly.
• Blown fuse or tripped
• Defective hose.
• Power unit overcurrent
3. Power • The unit power switch is in
unit runs
continuously
• An electrical short has
when the
hose is
removed.
OSSIBLE CAUSES
inlet.
other wall inlets.
circuit breaker has been
activated (the reset button
is popped up).
circuit breaker on house
electrical panel.
protector has been
activated.
ON position.
occured somewhere in the
system.
'
CONT D
P
OSSIBLE REMEDY
• Replace defective wall inlet.
Check
• Push
the circuit
b r e a k e r
reset button
located
the left side
of the power
unit. If this
button pops
up again,
contact your
authorized
S e r v i c e
Center.
• Replace fuse or reset circuit breaker on
house electrical panel.
• Replace hose as required.
• Unplug the power unit, wait at least 15
minutes and plug back the power unit.
• Set the unit power switch to OFF position.
• Perform a complete check of all wall inlets
and power unit low voltage control leads
connections. Contact your authorized
Service Center.
11
)
on
R
ESET
BUTTON
on
AC0003
P
OWER
SWITCH