Removal & Installation Of Secondary Hepa Filter (Pp650 Power Unit Only ) - NuTone PUREPOWER Serie Guia Del Usuario

OPERATION AND MAINTENANCE (
REMOVAL AND INSTALLATION OF SECONDARY HEPA FILTER
(PP650 POWER UNIT ONLY)
NOTE: This is a disposable HEPA filter; do not attempt to wash it since this will damage it.
This HEPA filter should be replaced every 5 years. Proceed as follow:

If installed, detach the exhaust line from the top of the unit.

Disassemble upper part from lower part top cap assembly by pushing on the 4 retaining
tabs (one by one) located on the lower part and pulling on upper part to disengage it.
NOTE: A small flat blade screwdriver can also be used to pry on the 4 retaining tabs, as
shown in illustration A at the bottom of the page.
Risk of warm surfaces and sharp edges. It is recommended to wear safety
gloves while handling this HEPA filter.

Discard the used filter and replace with a new one (part no. S10941416). Be sure to install
it with the gasket on top as shown in illustration B (at the bottom of the page), then snap in
place the upper part of the top cap. If need be, reconnect the exhaust line to the top cap.
4 X
AR0053
WARNING
!
A
'
CONT
7
)
D
B