NuTone PUREPOWER Serie Guia Del Usuario página 6

OPERATION AND MAINTENANCE ( ' )
CONT D
FOAM MOTOR FILTER (ALL UNITS)
A foam motor safety filter, located at the top of the vacuum chamber provides protection
against dirt being pulled into the motor if the disposable bag or sealed HEPA permanent filter
should accidentally be torn. This filter should be checked and cleaned if necessary when
replacement bag is installed, or when sealed HEPA permanent filter is removed (PP600 and
PP650 units only). Simply brush filter clean. If the filter is excessively soiled, hand wash in
a water and mild detergent solution, rinse and let it dry completely on a flat surface before
reinstalling.
CAUTION
Operating the power unit without the foam motor filter will void the warranty.
REMOVING FOAM MOTOR FILTER
Remove the debris pail and disposable bag or
permanent filter. Lift the center of the wire retaining the
foam motor filter and slide the filter out of its location.
REINSTALLING FOAM MOTOR FILTER
To reinstall the foam motor filter, reverse the steps
described above.
AD0086
6