Indicator Lights - GE G151 Manual Del Propietário

Controls (Cont.)
D
Load Size
– For convenience, best performance and optimal efficiency, select PreciseFill. This selection automatically provides the correct amount of water suited to
the size and type of load placed in the unit. NOTE: The washer will not fill with water when PreciseFill is selected if the lid is opened.
– If you prefer to manually select the water level, depress the Load Size button to highlight the desired selection. While PreciseFill is best for most loads
and general washing, you may want to manually select the load size for specialty items such as bulky, lightweight comforters or pillows, where you
want to ensure a larger water level is applied. Manual load size selections should be made for wet items placed in the washer, such as soaked towels or
garments.
– Some models are equipped with a "Deep Fill" setting. This is ideal for washing bulky items or when a maximum water level is desired.
E Power
Press to "wake up" the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing POWER does not disconnect the appliance from the power supply.
Start
F
Press Start to begin the cycle. NOTE: The lid must be closed for the washer to fill and the cycle to start. Pressing Start again will
Pause the cycle and the Cycle indicator light will blink.
To continue the cycle, press Start again or close the lid. If machine is paused more than 24 hours, the cycle will be cancelled. To stop the
cycle, hold the pad for 3 seconds. If water remains in the machine, select the Drain & Spin cycle to drain tub and spin water out of the
washer tub.
Raising the lid will stop agitation or spin action but does not pause the cycle.
eWash (on some models) -
G
lights will now illuminate to indicate the relative efficiency of the modified cycle.
H Display
(on some models) - The display shows the approximate time remaining until the end of the cycle.
NOTE: The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure in your home. The "smart" timer
"learns" the amount of time it takes to fill your washer and adjusts the total time accordingly.
In addition, this display will, "scroll" the washer status:
• bALANCING
Start of rebalancing cycle to redistribute clothes. Stops after rebalancing is complete.
• dELAY
When Delayed Wash is initiated. Replaced with estimated time when cycle starts.
• End
End of current cycle.
• FILL
For the first 45 seconds of a fill, the estimated end of cycle time is displayed. For the rest of the fill time, "FILL" is scrolled
until the fill completes.
• LID
Cycle stopped because lid is open. Close the lid.
• PAUSE
Cycle paused because the Start/Pause pad was pressed and the washer was set to Pause. Press Start pad again to
restart the cycle.

Indicator lights

I
Five LED lights indicate the current washer status moving from left to right as the cycle progresses.
6
When the eWash pad is pressed, the cycle changes to its most energy efficient settings. The eMonitor