Setting The Time And Date; Fm Radio Operation - Multilaser Rock Manual Del Usuario

volume.
When the player is muted,the display shows a speaker icon crossed in red and "MUTE" text.

5. Setting the time and date

In the power-on status, press " /CLK" button briefly, the current date and time is show on the dis-
play. Then, press and hold the 3/REP button for 2 seconds,the "Hour" item is blinking, you can adjust the
desired value by press the  and ,buttons, press 3/REP button repeatedly switch to other item setting.
Finally, press 3/ REP for 2 seconds to confirm the adjustment.
When the date and time showing, if you do not press any button for 10 seconds or press " /CLK"
button again, the display reverts to the original mode.

FM Radio Operation

When you turn on the player, the FM receiver will come on if it was the last selected signal source,
or if you have removed the last used USB stick or SD card.
If needed, use the MODE button to select the FM receiver function.
1. Automatic tuning and storage
To start a scan and store the currently available FM stations, press and hold the BAND button for 2
seconds. You can follow the scanning and memorizing process on the display.
If there are enough channels available, the player will move on to FM2 and FM3 after filling in the six
slots of first band FM1.
• The player can store up to 18 FM radio stations. (FM1/FM2/FM3 with 6 channels each).
• Keep in mind that the receiver may skip weaker stations, and you cannot influence the order in
which the stations are stored.
• If you wish to store a station in a particular slot, you need to manually tune in to its frequency and
store it.
• If you are using the receiver at a distant place from the location where you originally stored a sta-
tion (e.g., when you are traveling), you may need to find the same station again at a different frequency.
The same stations often air at different frequencies in different geographical locations!
multilaser
www. .com.br
21