2. Selecting a stored frequency
Press and hold the button corresponding to the station's slot (1...6) briefly.Make sure to select the
right band (FM1/FM2/FM3) first by pressing BAND.
3. Manual tuning, storing frequencies
Press the and button briefly to manually tune in to the desired station, or press and hold the
e buttons to scan automatically for the stronger stations. The scan stops when the player reaches
the next available station.
4. Radio browse function
When you listen to the radio , press and hold 2/INT for 2 seconds, then it comes to the state of "FM
browse start" mode. the player plays the first 10 seconds of every available radio stations.Radio browse
mode will be exited when 2/INT pressed again.
Music playback
(from usb/sd/mmc storage devices)
1. If you wish to listen to MP3 tracks from a USB/SD/MMC storage device and the FM receiver is
currently active, you simply need to connect the USB stick or insert the memory card. The player detects
this and starts playback automatically. The display then shows the track's number,song name and the
elapsed time.
• If both a USB stick and an SD/MMC card is connected at the same time, the player will play the
tracks from the one you inserted last.
• If the player emits no sound or does not recognize the USB/SD/MMC memory, remove the storage
device and connect it again. If this does not work either, press the MODE button to select the signal
source.
2. Press 1/ button to toggle between playback and pause.
3. Press and repeatedly to move to the previous or next track.
If you press and hold these buttons, you can jump 10 tracks forward or backward. If there are less
than 10 tracks remaining at the start or end of the playlist, the player goes to the first or last track
4. During the playback, press 2/INT to track intro function, the player plays the first 10 seconds of
every available MP3 track. If you choose to play an entire track, press 2/INT again to exit the intro mode
and continue playing the current track.
22