For Your Safety; Getting Started - STEINEL HB 1750 Manual De Instrucciones

For your safety

This heat tool incorporates a thermal fuse which automatically switches the device off in cases of severe
overheating.

Getting started

Operation
The device is switched on and off
with the selector switch on the
front of the handle. The distance
from the object being processed
depends on the material and the
intended type of processing.
Temperature Selection
Level 1 is the cool air setting. The
temperature is approximately 80°F
(room temperature). Use the cool
air function to dry paint, to cool
workpieces or to cool the nozzle
before changing an accessory
part. At Level 2 the blower tem-
perature is determined by means
Adjustable Baffle
Turn the baffle 7 to adjust the
air and temperature within the
range allowed by the key in use.
Turning the baffle toward LO low-
Working with the stand
Push the quick-lock switch
on the base using your thumb
and index finger and set the
Changing the heating element
The HB 1750's plug-in heating
element is quick and easy to
change.
1. Caution! Disconnect the
device from the power supply.
Exercise caution if the device
was being used previously.
Always do an initial test with re-
gard to air volume and tempera-
ture. With the optional accessory
nozzles (see accessories on page
3), the hot air can be precisely
targeted to specific points or sur-
of the key used and the position of
the rotary wheel. Color coded keys
each lock in a specific temperature
range. When not in use, keys may
be stored on the convenient base.
Disconnect the device from the
power supply before changing the
keys. Remove the key to be
ers the temperature while increas-
ing the airflow. Turning the baffle
toward HI increases the tempera-
ture while decreasing the airflow.
device into the guide channel.
11
Then release. Press the locking
switch to adjust the blower
The protective tubing will be
very hot. Let it cool down first!
2. Unscrew the the two screws
3
at the end of the protective
tubing.
3. Remove the protective tubing.
4. Remove the heating element
and replace it with a new one.
English
- 7 -
faces. Exercise caution when
changing hot nozzles! When
you use the heat gun as a sta-
tionary device, ensure that it is
positioned securely on a clean
surface so that it cannot slip.
changed from the device using
your thumb and index finger.
Select the desired temperature key
from the stand and insert it into the
unit. After the key locks into the
unit, the device can be switched
on again.
See Technical Specifications for
the temperature range defined by
each key.
direction of the HB 1750 by
swivelling it.
5. Replace the protective tubing
and screw it tight.